Usable bar length:
The housing, rounded base columns and the rear wall are made of AISI 304 stainless steel with semi-gloss finish. Base columns are empty and can be used to integrate components provided by the customer. The rotary head and other electrical and mechanical components are integrated into the centre housing. In case of multiple installations, the housing unit acts as a guiding element – additional guiding bars are not required. To improve personal safety, standards and guidelines relating to points where body parts could get pinched or squashed have been taken into account in the development of the tripod barrier (Machinery Directive 2006/42/EC).
AISI 304 stainless steel with smooth semi-gloss finish.
Aggregate type 2
The rigid crossbars are made of AISI 304 stainless steel. The tripod barrier is equipped with a servo-positioning drive (low energy drive with energy content
Since the drive and the locking devices are mechanically separated, low energy drives can be used to provide personal protection. On the other hand, high locking forces can be used to prevent unauthorised passage through the unit. Parameters can be set for unit behaviour and each specific customer (e.g. starting behaviour and passage speed).
MCBF (mean cycles between failure) is 5 million.
The control unit and power supply unit are integrated into the unit.
Power supply 100–240 V 50/60 Hz. The units with aggregate type 2 can be networked to one another.
Three floating messages (closer and opener) for type 2: rotation message entry, rotation message exit, message ready.
The tripod barrier is dowelled at finished floor level FFL and is suitable for outdoor installation.
Passage side inwards right / Passage side inwards left
Counter for one direction
Counter installed inside.
Permanent release in exit direction / Permanent release in entry direction
Fold down bars
The upper bar folds down when a button is pressed (on-site signal) or in the event of a power failure. The reset is initiated manually. The reset is initiated automatically for type 2 units (patented process).
Apparent installation of card reader on beveled portions of
the casing, which may be stainless steel or plastic
Push button on flat surface
For manual single release (installed pointing inwards).
Operating panel OPL05
For installation in flush-mounted socket with grey single installation frame. Outer dimensions: 80 mm x 80 mm. Film keypad with six push buttons and six green LEDs.
Parameters can be set for the functions depending on the unit (details can be found in document 30078).
LED arrow-cross signal device
Red/green pictogram (Ø 90 mm) installed on both sides in the housing (flat surface), intensive luminosity.
Installation of flush-mounted socket in the housing
To install components provided by the customer.
Delivery Time (standard): 15 working days