Guiding elements made of tubular AISI 304 stainless steel tubes Ø 60 mm with TSG 10 mm glass panel and AISI 304 hand rail. Two door leaves are made of transparent polycarbonate door leaves, thickness 10 mm, upper edge 900 mm.
The sensor system is attached horizontally and vertically to the guiding elements. The sensors have stainless steel plate cladding and infrared-permeable plastic covers. The drives are installed in the housing. The drive housing is made of AISI 304 stainless steel.
In case of multiple installations, the housing unit acts as a guiding element – additional guiding bars are not required. The passage width can be widened to 900 mm when necessary for passage or for passage of people with reduced mobility.
To improve personal safety, standards and guidelines relating to points where body parts could get pinched or squashed have been taken into account in the development of the sensor barrier (Machinery Directive 2006/42/EC).
Stainless steel semi-gloss smooth finish.
Aggregate type 2
The sensor barrier is equipped with two servo positioning drives (low energy drives with energy content
The passage area is monitored by an advanced sensor system with an optimised length and configuration. This allows for enhanced monitoring of single-file passage in both directions (safety level 2). This sensor system also monitors the swinging area and the blocking elements and acts as a protection device. Sneak-by guard, detection of trolleys and children are integrated into the unit.
In the event of a power failure, both directions may be freely accessed. Automatic reset upon resumption of power supply – the unit resets to its regular function without manual intervention The access area is secured immediately upon resumption of power supply. The unit can be locked in any position and opens under load (personal safety in case of panic). In basic position, the unit is unlocked to minimise power consumption. Parameters can be set for unit behaviour and each specific customer (e.g. starting behaviour and passage speed).
Available operating modes:
Open basic mode:
The door leaves close automatically if someone passes through who is not authorised. If an authorised individual passes through, the door leaves stay open.
Closed basic mode:
The door leaves open automatically if the individual is authorised in the direction of passage and then close again.
If passage is authorised, it is not possible for someone without authorisation to pass through from the opposite direction. If no one passes through the unit within an adjustable time after the release signal, the release is automatically deleted. In the event of a power failure, the door leaves can be moved in both directions.
MCBF (mean cycles between failure)
Passage width: 650mm = 8 million, 900mm = 6 million
Control unit and power supply unit are integrated into the unit.
Power supply 100-120 V / 200-240 V 50-60 Hz
The sensor barrier is dowelled at finished floor level FFL and is not suitable for outdoor installation.
Version as single, double, triple, quadruple, quintuple, sextuple, septuple or octuple unit
For the installation preparation of components provided by the customer or for installations by Kaba, e.g. reader, emergency button.
LED arrow-cross signal device
Red/green pictogram (Ø 90 mm) installed on both sides in the cover plate (flat surface). Intensive luminosity! No other components possible!
Operating panel OPL05
For installation in flush-mounted socket with grey single installation frame. Outer dimensions: 80 mm x 80 mm. Film keypad with six push buttons and six green LEDs.
Delivery Time (standard): 30 working days